IMPORTANT NOTE: This product is being phased out by end of Q2, 2020. At that time, limited product may be available. Please contact your GM customer service rep. Please see new LEDTask™ 2020 RGBW product here.
Outdoor use of RGB Flexible LED Linear Tape is easily achieved with GM Lighting’s wet location RGB tape. The product has all the attributes of the standard output RGB Flexible LED Linear Tape, encased in a flexible waterproof sheath.
|Catalog No.||Color||Total LEDs||LED Watts||Amps/Reel||Lumens/Foot||Length|
|LTR30WP-RGB||RGB Color Changing||30 (9 per foot)||7.2W (2.2W per foot)||0.6||64||1M (39.4")|
|LTR150WP-RGB||RGB Color Changing||150 (9 per foot)||36W (2.2W per foot)||3.0||64||5M (16'4")|
5 Meter Reel includes: (1) RPS-24-WP wet location tape to RGB controller connector, (1) male connector affixed at start of reel, (20) silicone mounting clips, (40) stainless steel screws, (1) tube silicone sealant and (2) silicone end-caps. Limits: (4) RGB LED reels can be driven by (1) controller. Each reel must be wired directly back to the controller. For runs of (5) reels or more consult factory. Suitable for installation from -12°F to 150°F. 5 meter RGB wet location reels are not connectable.
Connectable 1 Meter Reel includes: (1) RPS-24-WP 24” wet location tape to RGB controller connector, (1) male waterproof connector affixed to end of tape, (1) female waterproof connector affixed to opposite end of tape which allows the ribbons to be connected together for various length applications, (6) silicone mounting clips, (12) stainless steel screws, tube of silicone sealant, 2 silicone end caps and 1 male silicone plug for plugging end of run.
NOTE: Use only electronic non dimmable power supplies. RGB brightness is controlled exclusively by the controller , do not dim on the primary side or use a dimmer switch. Max length of ribbon load on a given run is 1 reel(36watts). Multiple runs can be fed off of the controller and amplifiers. Do not exceed total maximum wattage loads on the controller or amplifier.(144w) Max load on the controller itself is 144watts, maximum load on any single amplifier is 144 watts. Each controller and amplifier requires a 12VDC input to power the load on that device. Multiple amps can be connected to the controller allowing for larger systems. Consult factory for assistance.
|RPS-24-WP||24" Flexible Tape to RGB Connector|
|RPS-72-WP||72" Flexible Tape to RGB Connector|
|RTRWP-12*||12" RGB Flexible Tape to Tape Connector|
|RTRWP-24*||24" RGB Flexible Tape to Tape Connector|
|RTRWP-36*||36" RGB Flexible Tape to Tape Connector|
|RTRWP-60*||60" RGB Flexible Tape to Tape Connector|
|WPKT-RGB||Waterproof accessory kit. Includes small tube of silicone sealant ,
1 silicone end cap, 6 silicone mounting clips and 12 stainless steel screws.