12VDC RGB Color Changing LED Amplifier





IMPORTANT NOTE:  This product is being phased out by end of Q2, 2020.  At that time, limited product may be available.  Please contact your GM customer service rep.  Please see new LEDTask™ 2020 RGBW product here.

RGB LED linear tape runs over 20 meters (more than 4 reels), require an amplifier.  The LTRGB-AMP enables longer runs to be controlled on one controller.  For longer runs requiring more amplifiers, please consult factory.


NOTE: Use only electronic non dimmable power supplies  RGB  brightness is controlled exclusively by the controller , do not dim on the primary side or use a dimmer switch. Max length of tape load on a given run is 1 reel(36watts). Multiple runs can be fed off of the controller and amplifiers.  Do not exceed total maximum wattage loads on the controller or amplifier.(144w)   Max load on the controller itself is 144watts, maximum load on any single amplifier is 144 watts. Each controller and amplifier requires a 12VDC input to power the load on that device.  Multiple amps can be connected to the controller allowing for larger systems. 



Ordering Information

Catalog No. Description Wattage Amps Finish
RGB-AMP 12VDC Flexible RGB LED Linear Amplifier 144W 16.0 Max Aluminum

Product Downloads

Product Catalog


Spec Sheets


RGB Amplifier



There are no Photometrics available for these products.



There are no drawings available for these products.



18700 Ridgeland Ave. Unit 150
Tinley Park, IL. 60477
Toll-Free (866) 671-0811
Fax: (708) 478-2640



Copyright © 2019, GM Lighting Inc. All Rights Reserved.